Metal Casting Zone

The Best Metal Casting Community on the Planet

Search Google

Search Metal Casting Zone
Welcome, Guest
Please Login or Register.    Lost Password?
Metal Casting Forum Furnace Info Casting Burners
HH's ComboWind Burner (1 viewing) (1) Guest
Everyone has a different patent on their burner design. Let you secret slip here.
Go to bottom Favoured: 3
TOPIC: HH's ComboWind Burner
#304
HH's ComboWind Burner 3 Years, 5 Months ago  
I call this a ComboWind because it can be run like an up-wind or a Reil type.
What I did was to drill a 1/4" compression fitting out so the tube could slide all the way through it and cut slots in the sides of the pipe.







Here is a vid if I can do this posting right.
HHWC3 (User)
Senior Boarder
Posts: 66
graphgraph
User Offline Click here to see the profile of this user
Logged Logged  
 
The administrator has disabled public write access.  
#551
Re:HH's ComboWind Burner 3 Years, 5 Months ago  
What orfice size are you useing for the propane? Looks like it works very well.
aonemarine (Moderator)
Administrator
Posts: 716
graphgraph
User Offline Click here to see the profile of this user
Logged Logged  
 
The administrator has disabled public write access.  
#553
Re:HH's ComboWind Burner 3 Years, 5 Months ago  
Nice, very nice!!!
kineticdc (Moderator)
Moderator
Posts: 118
graphgraph
User Offline Click here to see the profile of this user
Logged Logged  
 
Aluminum Die Casting Company
 
The administrator has disabled public write access.  
#555
Re:HH's ComboWind Burner 3 Years, 5 Months ago  
aonemarine wrote:
What orfice size are you useing for the propane? Looks like it works very well.It is a #35 mig welding tip.
I soft soldered it on useing the stove in the house !


I used all the same fittings but for one reducer and the pipe to make a smaller burner with a tube. I just had to turn(in my drill press) the threads a bit(it still screws in) and cut slots in the tube end and by useing a hose clamp, I can go from the bigger to the smaller burner with few parts in all.
HHWC3 (User)
Senior Boarder
Posts: 66
graphgraph
User Offline Click here to see the profile of this user
Logged Logged  
 
The administrator has disabled public write access.  
#760
Re:HH's ComboWind Burner 3 Years, 2 Months ago  
i made my burner from old bbq burners but i moderfied a old oxy torch and put 100psi from the air compressor into the lpg what can i say ive been spending days just melting and casting since this improvement.
xlchainsaw (Moderator)
Administrator
Posts: 955
graph
User Offline Click here to see the profile of this user
Logged Logged  
 
The administrator has disabled public write access.  
Go to top
Powered by FireBoardget the latest posts directly to your desktop